In this article we will discuss all those necessary steps which you need to perform before solving networking related questions in RHCE exam. Don't skip this tutorial, giving few minutes to this could save you from huge problems in exam. All steps are given in a sequences don't skip them .
LAN driver is the top most part for network. To check it run setup command
Select network configuration from list
If you see LAN card here mean you have LAN driver
if you don't see here anything and Linux drop you back on list manu means you don't have LAN driver. Install is first.
All systems on RHCE exam should have an properly configured IP address. During this entire practical we are using three systems. There description is given below Check these systems for properly configured IP address.
If you have skipped hostname during installation then it would be localhost.localdomain. You can change hostname with hostname command but this change would be temporary. To change hostname permanently do editing in /etc/sysconfig/network.
set computer name as shown in table.
On server system set it to Server and in client system set it Client1
Several Linux server depend name resolution. This file should have entry of all network systems. It will save you from naming related problem. In our network it should look like this on both Linux system Server and Client1
Firewall is the necessary security part of Linux system which is connected to Internet. But in exam we are not going to use Internet so it’s good practice to disable it.
To disable firewall run setup commands
Now select firewall configuration from list and click on run tool
Select disable and click on ok and quit to return on command prompt.
System reboot require to take effect so reboot system with reboot -f commands
Almost every Linux server needs these two rpm to function properly. First check that these rpm are install or not. If no rpm is install then install them via rpm commands.
If you have rpm then check there status via setup commands
Now select system service from menu
put a star in front the portmap service
Now put star in front the xinetd service
Click on ok and select quit to come back on command prompt
Now restart these two service.
To keep on these services after reboot on then via chkconfig command
After reboot verify their status. It must be in running condition
Once you have successfully completed these steps you are ready to configure the Linux server .
Search more about
Search in Google for